The castings were of ok quality, not too many air bubbles to deal with on the resin bits.
No real probs that some filler and a good rubdown couldn't take care of.
The surface smoothness of the resin cast parts for the figure was another story.

To be blunt, after a good scrub to get rid of any mould release and a quick blast of primer
it looked like the master had been gone over with a wire brush prior to moulding up.

Oh much primer/filler and elbow grease was used but still not that great,
primer was finally applied after much farting about and painting commenced.
Since this was for my own enjoyment, I didn't go all out as after two days of working down the surface,
I wasn't enjoying it that much all of a sudden like.
Still, I persevered like ya do.