This wee beastie run up on my Velleman K8200.
Just a start to finish test to find out if this would work.

The grip, guard, blade and scabbard were printed in ABS with additional
photo etch brass and cord applied by my none to dainty ham fists.

Also proved to be a good work out for the new E3D version 6 hot end which works bloody lovely!
Main aim for this is part of a large scale figure that sort of a collaborative effort between me and
my best friend Chris.

All told it's just under 14 and 3/4 inches long or 37 cm if you will.

Below is a just shy of four minute YouTube based video with me waffling over it about this here bladed thingy.